Moen Rain Shower Head Installation

Home » Hardware » Moen Rain Shower Head Installation

Moen rain shower head – The Moen rainwater shower head gives a soothing difference shower experience. It is not difficult to install Moen rainwater shower head. You must take precautions when removing the existing shower head. This is to avoid damage to the spray arm or wall plumbing. The shower head may require some force when you turn it off. Which will require you to hold the shower arm tightly, so that the arm does not rotate with the shower head.

Posted on November 23, 2017 Hardware

Instructions to install moen rain shower head: Place a cloth around the neck of the shower head where it connects to the shower arm. Locking a couple vice roof over the tablecloth and connectivity. Second, hold the spray arm with one hand near the wall and turning the vice control counterclockwise to loosen the shower head from the arm. By holding the shower arm in this way, you will prevent twisting the shower arm inside the soft copper pipes behind the wall.

8 Photos Gallery of: Moen Rain Shower Head Installation

Clean the old plumbers tape from the threads of the shower arm with a soft cloth. If necessary, remove stuck plumber’s tape from the threads with a stiff brush or old toothbrush. Extract new plumber’s tape around the threads of the shower arm. Fourth, place the new rubber washer into the neck of Moen rainwater shower head. The machine should sit flat and have no bends or twists. Last, three moen rain shower head on the shower arm to the shower head is hand. Use a wrench to turn the coupling nut half a turn to fully secure the shower head.

RELATED TOPIC :   New Cabinet Kitchen with Brass Pulls